Speed mountings

[Syd Thomas]

  Hi everyone. I just stripped the front end and replaced the headstock bearings. When I took the speed off it was quite a tight fit on the top yoke. Now putting it back together there is quite a lot of play. I don't think anything has fallen out and is now missing from the reassembley, the bike is on a workshop lift in a clean workshop. Nothing has fallen on the lift or floor that I can see. Does anyone know how they should fit and are there any bspacers or bushes? The exploded view in the workshop manual doesn't show any.?

[Hooli]

Do you mean the speedo? as in both clocks etc?

If so, it's two allen bolts from underneath the top yoke & yes there is play. I think they are mounted with rubber bushes that are part of the mounting plate (but it's been a while since I looked).