Non start and gauges not sweeping

[Steve H]

Hi
Been running fine, laid up for a few weeks and now have issue.

Turn ign on no movement on speedo/rev counter needles, nothing displayed in LCD display, fuel pump not running. Can hear a click fro assume relay when switching on.

Battery is fully charged and turns over well, any ideas???

[KiwiCol]

Gidday, you say the bike turns over, but clocks don't sweep & fuel pump doesn't operate? 

If it was running ok when you put it away & now it doesn't, then something has happened to it over the lay up time.  Mice?  Not a joke, it's happened before where mice have chewed through wires n buggered things. One even built a nest in the exhaust pipe!

[seth]

 
Nice first post not 

I'd be checking all the connections in the loom and give them a clean .
Be extra careful with the headlight ones and hopefully all will be good again

[Andre]

Most likely moisture/corrosion. First I would check/clean the connectors inside the headlight with contact cleaner.

[froudy]

Make sure to check the large grey block connector behind the right hand side side panel