power loss

[Hooli]

No pic but the pipe in the centre goes to the MAP sensor under the tank, but the bike won't idle with that disconnected (I know as I've tried this after balancing the throttles & forgetting to reconnect it).

The pipe to the left goes to the pairs valve further forward under the tank.

[mark.knights]

no the one under the tank has a different part number and part name ...so they look the same but there not ,,,,looks like giving the local muppits at the shop a ring and book it in ..no good shops  where I live 

[mark.knights]

my pipe on the left is actuerley on the right and has no conection fitting on the left side guess ther difrent depending on the k7 thing ..I have a pipe in middle and a pipe on the right side,,,no air leaks ive sprayed a lighter gas can all over

[Hooli]

No they are all the same, I just hadn't noticed that pic is taken from the engine side.

So as fitted to the bike, the centre one goes to the MAP sensor under the middle of the tank & the other goes to the pairs valve.

[mark.knights]

Its fixed tuurned out to be sensor under the tank the sensors are the same as the air filter one ..robinson foundery were confusing they have it down on parts list as 2 seprate parts and part numbers I rang them and its a mistake on ther parts page and told me yes bothe sensors r the same . So its finaly fixed new sensor 

[gsxbarmy]

Well done for tracking that down Mark, as that's quite an obscure fault with that sensor going - and well done on sorting out Robinson's as well!