Just wondering if these are the same on the Bandit 1200 and GSX 1400 engines.
Cheers, Alan.
I for sure hope so... Recently bought a set of stainless steel b12 ones to replace mines. ;)
Hi,
Fairly sure they are but give Just Bandits a call and Julian will be able to confirm
http://www.justbandits.com/cam-bolts-set-of-8.html (http://www.justbandits.com/cam-bolts-set-of-8.html)
Regards
Ian
Yes they are the same
I fitted a set off for Bandit 12. Cost about £14 of eBay. There was a link off the old forum. Load of us bought a set. Little cheaper too...
Magic. Thanks very glad for the replies.
Looks like THESE (clicky) (http://www.ebay.co.uk/itm/152657751928?euid=841207c8e62543ceb8c6685a6fb9343d&bu=43219406492&cp=1&sojTags=bu=bu) are good value then.
I'll get some ordered to swap for the skaggy ones on my 'new' 14. :)
Them's the ones and top value as well :onya:
Be gentle taking your old cam bolts out though, as you'll need to re-use the rubber seals off the originals
Hmmm. They are nice. Mine were stainless.
Quote from: gsxbarmy on Thursday, 31 August 2017, 12:28 AM
Them's the ones and top value as well :onya:
Be gentle taking your old cam bolts out though, as you'll need to re-use the rubber seals off the originals
... and put a dab of motor oil on them seals.
Quote from: Andre on Thursday, 31 August 2017, 01:51 AM
Quote from: gsxbarmy on Thursday, 31 August 2017, 12:28 AM
Them's the ones and top value as well :onya:
Be gentle taking your old cam bolts out though, as you'll need to re-use the rubber seals off the originals
... and put a dab of motor oil on them seals.
good tip andre :onya:
Make sure the threads & hole is clean when you put them in. Helicoiling the cam journal is a pain when you shouldn't have needed to do it & the metal is damn soft.
They are M7 threads if/when you need to do it btw.
If I remember right. Two are impossible to get a torque wrench in. Due to frame rails.
Unless lump is out on a bench. So be careful.
No problems to get the torque wrench in when I did mine. Guess it might depend on the size of the wrench and/or what you take off (took everything off as per service manual to take off head cover).
Typical - sold out and getting more 'in a couple of weeks.
Bet this turns into a saga, I'm dead lucky like that.
check the part numbers on Robinsons web site.
you can check if any other suzuki one are the same then you can search for those too .
it might help you get your bolts quicker .
:cheers:
Quote from: Alan H on Tuesday, 05 September 2017, 01:17 AM
Typical - sold out and getting more 'in a couple of weeks.
Bet this turns into a saga, I'm dead lucky like that.
The guy on eBay does tend to do them in batches - so if he says in a couple of weeks they will be there (in a couple of weeks or so) - just got to keep an eye out!