Continuing - So what did you do to your bike today...?

[Snapey]

I made stainless ones Reece to suit the hand guards. They're a nice sliding fit in the bars (ProTapers) held there by an M4 grub screw tapped through the bars 10mm from the ends. A small indent in the end weight locates it. You need to peel the clutch side grip back to access the screw or just punch a small hole in the grip.

[Reece]

They look good snapey.

[seth]

 

[coldhands]

Would be great for my coldhands 

[ogrimark]

I took the ESL bars, heated grips, givi lugguage and aftermarket exhaust off my black bike ready for it being picked up on Thursday 
then I sold the lugguage 
the exhaust and bars are put to one side for when blue gets rebuilt.

'when blue gets rebuilt' is turning into a far too often said phrase.
as soon as the chop is off the bench blue is on and stripped.
hopefully soon 

[ogrimark]

Went for a picnic with the Family today,
Saw loads of bikes out, driving me crazy that mines not ready yet so went to the garage 5-7pm
Nearly there now

Like it. Black as Fark apart from one red nut 

[Red Biker]

lol thanks Mark, it kinda has my personality on it 😳

[Big Geordi]

I mostly removed the Repsol orange paint and fitted new Sprocket etc

[Red Biker]

Pretty fancy Dan Bolts there BG, will it be a Blue chain?

Red

[Mick_J]

Fitted my new hand guards last night, will give them a try today.

[grog]

did not a lot. have cleaned/polished every bit i can find. even layed on floor and did bits that get missed. tomorow , easter monday. taking wife for lunch. tiny little ride. were going to the worst most horrible pub just north. dangerous at night, should be ok for lunch. food is brilliant. just something different. life is to short to let it be boring.

[Reece]

I made stainless ones Reece to suit the hand guards. They're a nice sliding fit in the bars (ProTapers) held there by an M4 grub screw tapped through the bars 10mm from the ends. A small indent in the end weight locates it. You need to peel the clutch side grip back to access the screw or just punch a small hole in the grip.

Could I please get picture of how it is mounted to bars.

[northern]

1. Get some goodies from ProBolt 
2. put some new shine on grab rail - it was polished 2 years ago...

[northern]

Change heated grips controller bracket to DIY one

[Mick_J]

Prepped it for the MOT test, should pass with no advisories.