DIY Original Handelbar ends, on Renthals and others

[Icebreaker]

The way i solved this.
Nut, fuelhose, bar ends.....

Like ay glovve

[northern]

well done!
Like simple and reliable solutions.

Just want to point attention - Renthals have bung inside tubing, ~8 cm from the edge, so bolt can't be very long.

[Icebreaker]

Did not know this i do not have renthals

[froudy]

Good job there @Icebreaker 

I have Renthals on my Bandit and there is no bung in them..It must be something that they have done as a modification in the last few years.

[northern]

I have Renthals on my Bandit and there is no bung in them..It must be something that they have done as a modification in the last few years.

I have ultra-low, and fatbar from Renthals. Both have some-kind of silicone rubber inserts. Maybe, it's not hard to push them further in, but I never try.
And yes, they both have been purchased during last ~3 years.

[Notty]

I have Renthals on my Bandit and there is no bung in them..It must be something that they have done as a modification in the last few years.

I have ultra-low, and fatbar from Renthals. Both have some-kind of silicone rubber inserts. Maybe, it's not hard to push them further in, but I never try.
And yes, they both have been purchased during last ~3 years.

My Rentals are 6 months old and no bungs - had to make my own to fit my bar ends