Snapey's garage

[Irish in Oz]

440Volt. You should not have to do anything to links in motors, only important thing is up/down direction is right or you could strip gears as over travel limits will not work. You will need another 3 phase outlet. Will not run on 240 Volt too technical to explain on here 

[Irish in Oz]

Pete the 80mm tool post sounds good from memory the centre hole was about 20mm stepped into a 14mm bolt thread.

[Snapey]

Thanks Jeff ... just thought I'd ask. Looks like I'll be running some 3 phase cable in the next few days after I figure out which one of the five wires in the cable misses out on a terminal in the 4 pin plug.

The tool posts are 65mm square & 50mm high with a 15mm hole up the guts.

[Irish in Oz]

That post will do fine, will probably need adjusted in centre anyway.
If you are using that orange circular cable in pic you won't need the neutral (black).

[Snapey]

That post will do fine, will probably need adjusted in centre anyway.
If you are using that orange circular cable in pic you won't need the neutral (black).

What I'll do Jeff is put anything aside I think you could use on a small lathe.

Black is neutral eh! Sounds good to me.