Fast idle

[Eric GSX1400K3]

That's how I read it too Col.  Issue is 0.035V is so small that just moving the connector slightly would see a change larger than that, and adjusting the TPS by that minuscule amount is yet another challenge.  Just by tightening the security torx on the sensor you get 0.1 to 0.2v differences.

[KiwiCol]

It's as Hooli says, hit & miss. 

[grog]

I reckon a magician required to see.03v. BAnz, my advice, set your tps at 1100ohms or close closed, set your idle speed 1100rpm.over time from cold, adjust cold start idle until acceptable to you.She should be ok then just leave it alone, set and forget.If you really want/need quicker reaction off the line, fit atre and R1 Yamaha throttle tube, thatll do it👍