Accessing rear tail / brake lighst to change bulbs?

[VladTepes]

Stupid question but I can't seem to find the right section in any of the manuals I have to hand.
Can anyone point me the right way please?  Ta.

[KiwiCol]

In behind the tool kit isn't it?   

[seth]

As col says behind the tool kit
Its daily straightforward to change bulbs and indicators but if you need to get into wiring it's easier if you remove the tail plastics.

[grog]

so Vlad, why do you need brake lights if you dont have any brakes? 

[VladTepes]

so Vlad, why do you need brake lights if you dont have any brakes? 

OK, you win the internet today !

[gsxbarmy]

Mike to fit the bulbs I sent you, you will need to remove the tail plastics to get to the tail light, as, as I said in my note you need to file a gnats doodah off where they fit in fir the bulbs to go though. And it literally is just a gnats !!

[seth]

Is that a British gnat or an Australasian gnat as thiers are much bigger and scary than ours 

[VladTepes]

That's not what I wanted to hear barmy because to do that I will no doubt have to remove the givi rack too - and from last time I did this is is a royal PITA to get everything bolted back up. sigh.

Well, not today then.

[gsxbarmy]

You might be able to do it in situ Mike with the tool pack taken out - or just try the bulb through yours as is, it may fit with a bit of jiggling, if not you may just be able to run a round file  around it in place. It is only a smidgen if so.