Fuel regulator o ring size?

[Banditowner1200]

Hi all.
I've looked on here for what I'm after, however can't find the measurements for the o ring size needed for the fuel regulator.
I gather all gsx fuel regs are all the same with the o ring size aswel?.
If anyone knows the size then the help is appreciated. Cheers.

[Mick_J]

Someone posted the info last week, think it was chappers.

[Eric GSX1400K3]

Here you go.  I still haven't figured our how thr new photo upload works.

Just measured a spare I have.  OD is 14.6mm, ID 8.0mm and the o ring is 3.6mm thick.

[Dwain Dibley]

I think this is the post referred to above.

Here.

D.D.

[Banditowner1200]

Here you go.  I still haven't figured our how thr new photo upload works.

Just measured a spare I have.  OD is 14.6mm, ID 8.0mm and the o ring is 3.6mm thick.

Where did you order from? Looking online at suppliers is a nightmare to find stuff

[Eric GSX1400K3]

Hi Banditowner1200, I ordered a whole new quantum efi pump a while ago. The original pump is now in the shed. The quantum kit comes with a new reg and two o rings. I may have measured the old o ring, will check.

They are a tight fit into the housing, a smear of rubber grease does the trick.

The link that DD sent through will also help you