GSX1400 Owners .org
Technically Speaking => Modifications => Topic started by: mlivkovich on Saturday, 21 May 2022, 06:15 PM
I made it out of 5mm thick aluminium plate and some gasket paper. Bling that I like :smitten:
It looks great did you machine out the underside or it might actually restrict the engines breathing :cheers:
I just made much bigger hole in new plate :cheers:
Should there not be a tunnel between the top of the crankcase and the plate ?
Anyway it looks good so hopefully it all works well 😎
There is space about 3cm deep under plate and same dimensions as plate. On the right side there is hole cca 3x2 cm behind clutch and on the left bottom side there is 10mm hole just on top of gearbox.