Print Page - Non start and gauges not sweeping

Title: Non start and gauges not sweeping
Post by: Steve H on Tuesday, 02 July 2019, 03:10 AM

Hi
Been running fine, laid up for a few weeks and now have issue.

Turn ign on no movement on speedo/rev counter needles, nothing displayed in LCD display, fuel pump not running. Can hear a click fro assume relay when switching on.

Battery is fully charged and turns over well, any ideas???

Title: Re: Non start and gauges not sweeping
Post by: KiwiCol on Tuesday, 02 July 2019, 03:52 AM

Gidday, you say the bike turns over, but clocks don't sweep & fuel pump doesn't operate?

If it was running ok when you put it away & now it doesn't, then something has happened to it over the lay up time. Mice? Not a joke, it's happened before where mice have chewed through wires n buggered things. One even built a nest in the exhaust pipe!

Title: Re: Non start and gauges not sweeping
Post by: seth on Tuesday, 02 July 2019, 03:54 AM

:stir:
Nice first post not :frustrated:

I'd be checking all the connections in the loom and give them a clean .
Be extra careful with the headlight ones and hopefully all will be good again
:cheers:

Title: Re: Non start and gauges not sweeping
Post by: Andre on Tuesday, 02 July 2019, 04:02 AM

Most likely moisture/corrosion. First I would check/clean the connectors inside the headlight with contact cleaner.

Title: Re: Non start and gauges not sweeping
Post by: froudy on Tuesday, 02 July 2019, 07:57 PM

Make sure to check the large grey block connector behind the right hand side side panel :onya:

GSX1400 Owners .org

Technically Speaking => Electrics => Topic started by: Steve H on Tuesday, 02 July 2019, 03:10 AM