Hi guys not a member very long have started a rebuild after I had to switch out the engine and decide to powder coat the frame stuck on the loom at the moment with the routing of the harness around the air box and behind it any help or pictures would be greatly appreciated
A look in the manual, page 8-16, might help.
http://gsx1400owners.org/forum/index.php?action=downloads;cat=6 (http://gsx1400owners.org/forum/index.php?action=downloads;cat=6)
Over the airbox & along the left hand frame rail to the rear, the manual probably shows it better.
Take my tank of few days ago, and make this picture. May be it will help you a bit.
good luck :onya:
P.S. my signature also have link, where you could find some work in progress pics of my bike. May be you find something useful there.
Northern that fuel filter will never work there, your foot will keep hitting it :grin:
@grog hm... filter outside... Interesting solution :grin: Have to think about it, because filter I order few days ago is looking nice
But regarding picture - because my bit external filter do not fit under the tank, I had to place it under the seat. This make fuel line quite long, what allows not to disconnect it while I remove tank and put it on ground (an a towel) :)
Quote from: northern on Wednesday, 01 August 2018, 07:25 PM
P.S. my signature also have link, where you could find some work in progress pics of my bike. May be you find something useful there.
Lots of helpful pics/vids on various topics there :onya:
Look on page 45 of the Setup Manual (available to download in the manuals section), which tells you how to route the wiring loom
http://gsx1400owners.org/forum/index.php?action=downloads;sa=view;down=63
I took a photo of the area in question without my rear fender in situ..