Just wandering, which oil drain plug gaskets do you use ? OEM, which are kinda expensive and not always available, or local manufacture ?
Any the right size will do. They are just soft aluminium or copper crush washers essentially. As long as it doesn't leak after its all good :onya:
Yep, that´s what I´m gonna do from now on.
Just don't over tighten it and strip the sump threads out :onya:
I use copper washer. Sometimes, not every time, I do softening heating to washer, but I never change it.
Tightening always to 23 nm with a torque wrench.
Quote from: froudy on Saturday, 30 June 2018, 06:23 PM
Just don't over tighten it and strip the sump threads out :onya:
This is my daily bread I work with aircraft; thanks anyway. Always good to refer, if not for the more mechanically uninclined. I would prefer copper but more dificult to get around my place. Bought a couple of aluminium ones and they´re soft enough anyway.
i just undo fumoto. works for me, a lot will disagree. too low etc.
Quote from: grog on Sunday, 01 July 2018, 06:36 PM
i just undo fumoto. works for me, a lot will disagree. too low etc.
They work just great. Only issue is if you go over a very high speed bump (Vlad) or through a bloody big pot hole (Me) you end up snapping them off, wrecking the sump & loosing the oil all over the ground & rear tyre. It's a shame they hang just a tad too low & become the first point of contact under the bike.
I've not fitted one again since my disaster, just gently on the sump nut now.