Print Page - power commander 3 maps on to power commander v

Title: power commander 3 maps on to power commander v
Post by: seth on Friday, 03 February 2017, 08:32 PM

You can import a Power Commander III USB map into a Power Commander V by following the steps below.
In the PCV software, click on File, then Import PCIIIUSB map.
Click on a PCIIIUSB map, and then click Open. .
The PCIIIUSB map will be converted to PCV format, and opened in the PCV software. .
At this point you can either save this map on your computer in PCV format, or send the map to a Power Commander V. .

Title: Re: power commander 3 maps on to power commander v
Post by: Blubber on Friday, 03 February 2017, 10:27 PM

i believe you will be missing one RPM table.

please check , think it was 1200rpm

Title: Re: power commander 3 maps on to power commander v
Post by: seth on Saturday, 04 February 2017, 12:47 AM

ok will do
its a copy and paste from the dynajet/power commander web site in the f.a.q. section

Title: Re: power commander 3 maps on to power commander v
Post by: V_i_c_i on Friday, 27 October 2017, 12:40 AM

One note. If you convert PCIII map to PCV than autotune will not work.
Better is make new PCV map and than copy and past data from PCIII to PCV throught excel for example.

GSX1400 Owners .org

Technically Speaking => Fuelling => Topic started by: seth on Friday, 03 February 2017, 08:32 PM