Andys 14 turbo/ nitrous injection

[AndyB]

Cheers for that dave

[mlivkovich]

AndyB can you take some closer pictures of how and where are fuel pump and fuel pressure regulator mounted?
Thanx in advance

[froudy]

Can't believe that I somehow missed this thread topic

Great build @AndyB 

[AndyB]

AndyB can you take some closer pictures of how and where are fuel pump and fuel pressure regulator mounted?
Thanx in advance

All standard stuff mate....only mod I've done so far to the pump is safety wire the regulator in place.

[AndyB]

Can't believe that I somehow missed this thread topic

Great build @AndyB 

Cheers froudy,
I've got loads of pictures to up upload, but they are to big.if it wasn't for Mr barmy I wouldn't of had the last photos posted...I'm better with a spanner than a tablet..but I'm trying

[AndyB]

Ready to go down to BIG CC for mapping on Monday.
Just a quick seal and oil change on the forks this morning with stan from westgate super bikes ( Newcastle upon Tyne)
Stan is an accomplished turbo bike builder and world record holder for the fastest street legal gsxr1000 turbo in the world at 253mph  set at elvington  last year and works closely with Sean at BIG CC.

[AndyB]

STAN  from westgate super bikes ( hates his photo taken)

[AndyB]

Buttoned up and ready for mapping.
New power commander 5
New 3 bar map sensor
New KMS management system
New injection loom
Secondarys removed
And lots of other stuff

[AndyB]

7bTQJvXwCj8

[T 24]

Don't you use that Proboost secondary ECU anymore?

[grog]

Andy, what kind of power at back wheel? Sure have put some work into it 👍👍

[jimbob43]

I,ve bit the bullet and ordered the same kit from proboost, only issue is the plenum may have to be altered for my frame,

[AndyB]

Don't you use that Proboost secondary ECU anymore?

Hi jussi mate,
Hope you are well,
The proboost ECU had a massive malfunction and was unserviceable . 
I purchased a kronenbourg management system (KMS)
One reason for this is the tuner wouldnt touch the PB controller , hes the best in the country and just wont entertain them, 2nd reason is the KMS is far superior and gives you a huge amount of tuning points in comparison and is the choice in the northern hemisphere among the serious speed guys...

[AndyB]

Andy, what kind of power at back wheel? Sure have put some work into it 👍👍

I dunno yet grog mate,
Its away down to Big CC tomorrow via courier...but I'm away back offshore for 3 wks tomorrow too....
I,ll get an email off stan @ WSB with the print out...if it hasnt detonated on the dyno

[AndyB]

News from the dyno yesterday....first 3 pulls low boost ..3rd pull as you can see is
180hp at 175mph.
After some tuning magic.. a 4th pull at  - 243hp ,153 foot lbs torque .